Read more: How To Add LED Lights To a Bed?

Installing Emergency Lights

Before jumping into the installation process, always consult with an electrician to ensure compliance with safety procedures. If you prefer, you can also hire a professional to handle the installation. Regardless, it's vital to follow the instructions provided with the lights. Here are some key points to keep in mind:

Wall Mounting Installation:

1. Begin by removing the mounting pattern cutouts from the backplate to allow the wires to pass through effectively.
2. Install the provided bushing into the wire holes. These insulating tubes allow safe passage of electricity without direct contact with the fixture.
3. Pull the circuit wiring through the pass hole and attach it to the sign.

Ceiling or End-Mounted Lights Installation:

1. Remove the wire pass cutouts from the top or side of the unit.
2. Attach the canopy to the power pack or the sign itself using the provided screws and hardware.
3. Use the two longest screws in the outer holes of the hanging plate to attach the unit.
4. Pull the circuit wiring through the center hole in the plate and fasten the plate to the electrical box.
5. Guide the circuit wiring through the pass hole into the power pack.
6. Place the sign or fixture canopy onto the electrical box, ensuring the long plate screws pass through the holes.
7. Secure the sign or canopy using the supplied nuts.
8. Once the unit is mounted, the wiring is typically covered with a metal or thermoplastic housing.

Read more: How to Wire a Relay for Off-Road LED Lights

Regular Servicing of Emergency Lights

Installing emergency lights is just the first step; maintaining and servicing them is equally important. Regular servicing ensures that your emergency lights are in optimal working condition. Here are some tips for servicing your emergency lights:

1. Inspect the lights periodically to ensure they are clean and free of any dirt or debris that could obstruct their function.
2. Test the lights regularly to make sure they switch to battery power during a power outage or when a breaker is tripped.
3. Replace batteries according to the manufacturer's recommendations, typically every two to three years.
4. Clean the light fixtures and lenses to maintain their brightness and effectiveness.
5. Check the wiring connections to ensure they are secure and free from any damage or corrosion.
6. Keep a record of your servicing schedule and any maintenance performed to track the lights' performance over time.

Frequently Asked Questions

Q: Can I install emergency lights myself?
A: While it's possible to install emergency lights yourself, it is highly recommended to consult with an electrician or hire a professional to ensure proper installation and adherence to safety protocols.

Q: How often should emergency lights be serviced?
A: Emergency lights should be serviced regularly, ideally at least once every six months. However, the frequency may vary depending on specific regulations and guidelines in your area.

Q: Are there any legal requirements for installing emergency lights?
A: Yes, in most jurisdictions, there are legal requirements for the installation and servicing of emergency lights. It's crucial to research and comply with the local regulations to ensure you meet all necessary standards.

In conclusion, installing and servicing emergency lights require careful attention to ensure optimal functionality during emergencies. By following the installation steps and regularly servicing your lights, you can provide a safer environment for yourself, your family, or your employees. Remember, when it comes to emergency lights, proper installation and maintenance can make all the difference in critical situations.

Read more: What Are the Longest LED Strip Lights?