What surprised me when I first pulled one apart on a kitchen table was how little of the work is done by the straw itself, since the tube is just a hollow channel and the real function sits in the cap, where a hinge, a seal and a tiny air path decide whether the liquid stays put or climbs out. A Straw Plastic Water Bottle relies on that small assembly in the lid to turn a tilted body into a gentle sip, and once you see the parts laid out on a cloth the whole idea feels much less mysterious than the packaging suggests.
The cap is usually a few moulded pieces working together. A hinged flap or lever closes over the opening of the drinking spout, a soft ring presses against the neck of the body to stop liquid creeping up the thread, and a short channel inside the lid links the straw tube to the spout, so that suction at the mouth draws liquid up the tube and through the channel without any tilting at all. I like to hold the loose cap up to a window, because the outline of that channel shows through the plastic as a faint darker line.
Air is the part people overlook. When you draw liquid out of a closed body, something has to replace it, otherwise the walls squeeze inward and the sip gets harder with every mouthful, so a small vent is moulded into the lid, and a thin silicone valve or a tiny hole lets air in while the liquid stays out. If that opening gets blocked by dried juice, the sip turns stiff and the body gives a little crackling sound, which is usually the first sign that a lid needs a proper wash.
The sample on the table at Zuohao, a plastic factory in Taizhou that has made BPA-free water bottles for sports and daily hydration for over ten years, was a body with a flip cap and a straw, and next to it lay a loose lid with the tube pulled out, which made the layout of the channel easy to follow. I could only judge what was in front of me, namely that the thread was smooth, the flap closed with a small click and the seam on the body was even under a thumbnail.
The seal ring deserves a look, because it is a separate soft part and it is the thing that stops a drip in a bag. It sits in a groove inside the cap, and when the lid is screwed down it is squeezed against the rim of the body, so a ring that has slipped out of its groove or picked up a twist will let a thin line of liquid seep along the thread. I lift it with a fingernail, rinse the groove and press it back until it lies flat all the way round, which takes about as long as it takes to say it.
The straw tube is a plain length of plastic that reaches close to the bottom of the body, and its length matters more than it looks, because a tube that stops short leaves a puddle of liquid below it and a tube that touches the base can pull against it and slow the sip. A little weight or a bend at the tip is sometimes added so the opening stays under the surface when the body is tilted, and I check that the tube sits snugly on its connector, since a loose join sucks air and makes a rude noise.
The flap or lever is the user-facing part, and its hinge is a thin strip of plastic that is made to bend many times without snapping. I open and close it a few dozen times in a shop to feel for a stiff spot, and I press the flap shut and hold the body upside down over a sink to see whether anything creeps out. Cleaning follows the same layout, with the lid taken apart, the tube brushed through and the ring set back in its groove, and everything left open on a rack to dry.
Next time you see one on a shelf, look at the point where the tube meets the underside of the cap, where a small collar holds it in place, and you will find a tiny round vent near the spout. The product photographs on https://www.sportsplasticbottle.com show several straw caps from above, and on a Straw Plastic Water Bottle that vent is usually the smallest feature on the whole lid.