On a cold morning in a packaging plant I watched a technician crouch beside a Carton Folder Gluer Machine with a torch in one hand, running the beam along the underside of the frame before he touched a single control. A machine like this is built from steel, rubber, plastic and a few precision fittings, and each of those materials wears in its own way, so the sensible place to begin is with what you can see and feel before anything is switched on.
The frame carries everything else. Heavy steel plate or tube, welded and braced, keeps the folding section and the belts in line when the machine runs for hours, and a thin or poorly braced frame can twist slightly under load and drag the carton off square. I have no specification sheet for any particular model in front of me, so I describe the general picture. Look at the welds, which should be even and continuous, and press a palm on the side panel while the machine runs, because a steady, low hum is a better sign than a buzz that you can feel in your wrist.
Belts are the part that touches every carton, and they age like tires do. New ones feel slightly tacky and grip cleanly, while worn ones turn glossy and hard, and a belt that has begun to fray at the edge will eventually pull a blank sideways. Rollers deserve the same attention, so spin one by hand and listen for a smooth whisper instead of a gritty rumble, since a rough bearing announces itself long before it fails.
Guide rails and adjustment knobs take daily abuse. Operators slide them, lock them and knock them with stacks of board, so the rails should be straight, the scales readable and the knobs firm without play. I once ran a thumb along a rail whose paint had worn through at the same spot on every job, and the bare metal underneath had started to show a faint orange bloom from damp air, which is a cosmetic matter for a while and a warning if the plant is humid.
Glue brings its own problems. Residue builds up around nozzles and on nearby surfaces, and over time it can harden into crusts that need scraping, so look at how the parts near the glue path are finished and whether they wipe clean with a rag. Rubber seals and plastic fittings near the glue can stiffen with heat and repeated cleaning, and a hose that has gone hard and shiny is worth replacing before it cracks.
Dust is the quiet enemy in any carton plant, because paper fibers settle into every gap and mix with oil to form a gray paste on chains and slides. Guards, covers and fasteners should come off without stripping, and the screws should be of a type that can survive being removed many times, because a machine that cannot be opened easily tends to go uncleaned. A fresh coat of paint says little by itself, so I lift a guard and look at the unpainted corners instead.
Electrical parts and wiring are materials too, even if they hide behind a door. Cables should be neatly routed with clear labels and sleeves where they bend, connectors should click in firmly, and the cabinet should feel clean and dry inside. Ask the supplier in writing which components are fitted and where spare parts come from, since the long life of the whole machine often depends on one small belt or sensor being available when it is needed.
The listings at https://www.cenwanmachine.com/ show shapes and layouts in photographs, but the thickness of a side plate and the smoothness of a bearing only show up when you put a hand on them. At the end of every visit I do the same small thing, which is to wipe a finger along the inside of a guard on the Carton Folder Gluer Machine and look at how much gray dust and dried glue comes away on my skin.